• EKO International
Environmental measurement & analysis
EKO Instruments - clouds header

MC-11 Converter

MC-11 Converter

Features

  • Analogue sensor interface (V)
  • 4-20mA | 0-1600 W/m2 Irradiance
  • Optional USB contoller and EKO sense control software to change settings
The new 4...20mA converter called "MC-11" is a digital signal conditioner to convert the Voltage output of a Solar radiation sensor into a 4...20mA current output. The converter can be used with all passive EKO radiometers or any other mV sensor to be connected to dataloggers or inverters with a 4...20mA input channel. By using the signal conditioner the sensor cable can be easily extended over long distances without any signal loss or potential electromagnetic interference in noisy industrial environments.
 
For easy conversion the converter output for the solar sensor can be set to: 4-20mA = 0 - 1600 W/m2In combination with a solar sensor the sensitivity factor of the solar sensor will be preset to the converter.With the optional USB controller and EKO Sense software (Multiple languages) the converter settings can be freely changed. This tool will be needed in case the sensor sensitivity might need to be changed after a periodical solar sensor re-calibration. It has robust input/output screw terminals, which can be easily connected to the signal cable that leads to the measurements system at the installation site.
 

Specifications

Characteristics

Specification

Range settings

0-1600 W/m2 = 4-20mA

(or adjusted on request)

Input voltage range

0 to 100 mV

Resolution

<5µV

Input impedance

>10 MΩ

Temperature dependence

<0.2% (-20 to 50°C)

Non-linearity

< 0.1%

Updating time / Response time

<1s

W x L x H

Diameter 45 mm / h = 23mm

Operating temperature range

-40°C to +80°C

Ingress protection rating

-

Supply voltage

DC 12-24 V ±10%

Power consumption

0.08 ... 0.75 W 

Images

Downloads